KonFUSED 2 Way Fuse Distribution Block
The KonFUSED Distribution System is tailored by the installer to fit ANY installation requirement. With interchangeable Kompression Fittings anything is possible. The KNF-12 has one input port, which by changing the Kompression Fitting, can accept 4 Gauge or 1/0 Gauge Cable. The output side can be adjusted to accept 4 Gauge or 8 Gauge cables. Please see our reference chart link below to see what fittings are included with this model. Using the Mini-ANL Style Fuse, the KNF-12 can maintain loads up to 150A per circuit.
Included with the KNF-12 are 6 Kompression Fittings to allow the end user to customize the block to fit their application. The fittings available with the KNF-12 are: one large 1/0 Gauge; one large 4 gauge; two small 4 gauge; two small 8 gauge. The Large fittings are used on the input side and the small fittings are used on the output side of the KNF-12 Also included, your choice of two (2) Mini-ANL fuses! The KNF-12 is finished in black chrome and includes the smoke acrylic cover
Overview – KNF Series Fuse / Distribution Blocks use our compression fittings to secure the input and output cable connections. By changing the fitting type, the installer can select from 1/0 or 4 gauge input and 4 or 8 gauge fused outputs on the KNF-12. The above fitting chart shows the KNF-12's available user configurations using the included fittings. The KonFUSED distribution blocks all use Mini-ANL fuses which range from 30A to 150A. A clear black (smoke) protective cover is included with each block and is snapped into place.
Notes – The KNF-12 can provide 4 gauge in to dual 4 gauge fused outputs. When using this configuration, the total maximum fuse rating of the block should not exceed 150A (the max rating of our KFX series 4 gauge) This is because a single 4 gauge cable can not support the maximum draw of two 4 gauge outputs (300A) Please see our compression fittings how to for more information regarding fitting/wire installation here http://www.knukonceptz.com/assets/Tech/knfhowto.pdf
Please click on a product quesion below to reveal the answer.
How do I determine what size fuses I need for this fuse block?
Each output of a fuse distribution block normally is connected to a single amplifier. Each amplifier will have either a fuse on board or the manufacture will state within the manual's installation guide or spec sheet what the max fuse rating or current draw of the amplifier is. If your amp has three 30A fuses on boards, you want a 100A fuse for that particular output of this block (90A is not an option we offer). If the second amp has a single 40A fuse, then a 40A fuse goes into that output of the block and thus a 100A and 40A would be required.